4 Calling Procedures

Normally, C programs should call Racket procedures by using racket_apply, which calls the procedure in the initial Racket thread of the main Racket place. Chez Scheme entry points such as Scall0 and Scall directly call a procedure outside of any Racket thread, which will not work correctly with Racket facilities such as threads, parameters, continuations, or continuation marks.

ptr

 

racket_apply

(

ptr proc,

 

 

 

 

ptr arg_list)

Applies the Racket procedure proc to the list of arguments arg_list. The procedure is called in the original Racket thread of the main Racket place. Applying proc must not raise an exception or otherwise escape from the call to proc.

The result is a list of result values, where a single result from proc causes racket_apply to return a list of length one.

Other Racket threads can run during the call to proc. At the point that proc results, all Racket thread scheduling in the main Racket place is suspended. No garbage collections will occur, so other Racket places can block waiting for garbage collection.

ptr

 

Scall0

(

ptr proc)

ptr

 

Scall1

(

ptr proc,

 

 

 

 

ptr arg1)

ptr

 

Scall2

(

ptr proc,

 

 

 

 

ptr arg1,

 

 

 

 

ptr arg2)

ptr

 

Scall3

(

ptr proc,

 

 

 

 

ptr arg1,

 

 

 

 

ptr arg2,

 

 

 

 

ptr arg3)

Applies the Chez Scheme procedure proc to zero, one, two, or three arguments. Beware that not all Racket procedures are Chez Scheme procedures. (For example, an instance of a structure type that has prop:procedure is not a Chez Scheme procedure.)

The procedure is called outside of any Racket thread, and other Racket threads are not scheduled during the call to proc. A garbage collection may occur.

void

 

Sinitframe

(

iptr num_args)

void

 

Sput_arg

(

iptr i,

 

 

 

 

ptr arg)

ptr

 

Scall

(

ptr proc,

 

 

 

 

iptr num_args)

Similar to Scall0, but these functions are used in sequence to apply a Chez Scheme procedure to an arbitrary number of arguments. First, Sinitframe is called with the number of arguments. Then, each argument is installed with Sput_arg, where the i argument indicates the argumenrt position and arg is the argument value. Finally, Scall is called with the procedure and the number of arguments (which must match the number provided to Sinitframe).